
First Hour After a Burst Pipe in a Tampa Home
A split supply line or failed fitting can put a lot of water on the floor in a few minutes. The first hour is about stopping the water, staying away from electricity, and recording what happened.
Stop the water
Close the main house shutoff. If you are not sure where it is, see our guide to finding the main shutoff. Then open a low faucet to drain pressure from the lines, and turn off the water heater if the leak is near it.
Many Tampa Bay homes built from the late 1970s to the mid-1990s were plumbed with polybutylene supply pipe, which can fail without warning. Older homes often have cast iron drain lines. Either way, stop the water first.
Stay safe around electricity
Only switch breakers off if you can reach the panel from a dry spot. If water is near outlets or the panel, stay out and call the utility or 911. Keep people and pets off wet floors around cords and appliances.
Document, then start drying
Photograph the failed pipe or fitting before it is replaced, and film every wet room. Move furniture off wet carpet if you can do it safely. EPA advises drying wet materials within 24 to 48 hours. A plumber repairs the pipe; a water-damage business dries the structure. Some companies do both. Ask who is handling each part. In Florida, plumbing or building repairs require a contractor licensed under Chapter 489; verify at myfloridalicense.com.
Need a match? Use the form on our burst pipe cleanup page.
Free referral to an independent the Tampa Bay area business. Requests accepted 24/7.
Sources and local resources
Sources checked November 19, 2026. Local rules change; confirm details with the agency.